Page 2 of 2
Re: Need knowledge !
Posted: Fri May 06, 2016 9:05 pm
by JPG
dusty wrote:The Pivot Arm accepts the Way Tubes. The Base accepts the Bench Tubes. I have not seen it yet but the instructions (which you can download) tell you to insert the Bench Tubes until they make contact with the stop. The instructions emphasize that point.
Thank You.
I seems current(?) and future(?) Mark 7 have 52 3/4" way tubes.
Re: Need knowledge !
Posted: Sat May 07, 2016 5:31 am
by dusty
I don't like the fact that there is this opportunity for inconsistent assembly. I'll wait until I have assembled one before I speak anymore but I have an idea.
Re: Need knowledge !
Posted: Sat May 07, 2016 11:11 am
by JPG
dusty wrote:I don't like the fact that there is this opportunity for inconsistent assembly. I'll wait until I have assembled one before I speak anymore but I have an idea.
3/8" spacers not allowed!!!!
