Page 2 of 2
Posted: Tue Jun 03, 2008 10:02 pm
by joedw00
I'am not sure how long she had it storage. I can't find anything with a date on it. The good thing is that they caught the people that stole the stuff, but did not recover the Shopsmith. I will just hang on to it. I am sure I will be able to find some use for all of it. I still would like to find something on the Maxi-Clamps. I have no clue on how to go about using them.
Posted: Wed Jun 04, 2008 2:14 am
by a1gutterman
Hi kellycat,
kellycat wrote:...Also, What would I use the Speed increaser for? Routing? Or the biscuit Jointer?...
SS recommends it for routing and shaping
kellycat wrote:.... Not sure how the Right Angle fixture and the Repeat Positioner work yet either...
Both of these item work in conjunction with the Incra Ultimate Fence/Router System.
Nice score for $581!!
Maxi Clamps
Posted: Wed Jun 04, 2008 11:21 am
by johnmccrossen
joedw00,
I remember seeing an instruction sheet with the maxi-clamp set that was among the stuff that came with my old Mk 5. I will check in my binder to see if I can find it and either copy or scan it. I normally would have saved it. I will let you know.
John McCrossen
maxi clamps
Posted: Thu Jun 05, 2008 4:57 pm
by johnmccrossen
joedw00:
I did find the brochure. I tried to email you through this forum but have not received a response. You can let me know either via email or through this thread if you still need a copy.
John McCrossen
Maxi-Clamps
Posted: Thu Jun 05, 2008 9:32 pm
by joedw00
John
I received your email, and sent you my email address. Send it to
joedw00@yahoo.com, and THANK YOU!!!!!!!!
