Shopsmith Forums

@ JB what a nice job but you always do>
What is the tube on the BS near the blade top support? Air hose?

I thought I should post a picture of the quality of joints the I-Box jig is capable of. It is not only the I-Box however. The Forrest box joint blade set is a big player.

I don't know how one could get a better more precise joint.

Those joints are gonna really pop when finished!

JPG wrote:Those joints are gonna really pop when finished!

Ya swell and crack

Is this type of negative comment really necessary?

moose wrote:Is this type of negative comment really necessary?

Lighten up it was in sarcasm We all know it will not or at least all but maybe one

Sorry but 'we' did not 'all' know but thank you for changing your attitude.

ERLover wrote:

moose wrote:Is this type of negative comment really necessary?

Lighten up it was in sarcasm We all know it will not or at least all but maybe one

That's the problem with 'sarcasm'.

Same sometimes when said in jest.

If the intention is not clear it becomes misunderstood.

Yes I be guilty there as well.

Truth be told, if too tight, cracking may occur.

No that is NOT what I meant by 'POP'. I was referring to grain reveal.

@ JPG, >No that is NOT what I meant by 'POP'. I was referring to grain reveal.

I KNEW exactly what you meant. Just tried to throw some JPG humor back

Maybe, just maybe what a few of us should do is read and then reread what we have just written before it gets posted.

I delete almost as much as I end up posting.

When I say this I have just two or three active posters in mind. I shutter to think what some of the lurkers think. Maybe this is why they are lurkers and not "active members".

This is not the friendly forum that it once was.