Shopsmith Forums

Correction, it was Mike Young giving the demo. He and my neighbor Dave Young share a last name. They are both good guys.

moggymatt wrote:I enthuthsiasticly advertise for them every time someone asks "What did you make that with?". The response I usually get is "No way!".

I am a strong endorsement of SS also, I just bought a Jet TS from a guy, who is up grading, he delivered it Sees in moms garage a grayling and an ER, we talked SS, I showed him the ER original motor/bearings ect, the grayling with a BS and jointer/disk sander, he said Woh, just the 12" disk sander is worth 200$. I am honest, I said on these models the weak point is the TS do to
the small table, which on the new models has been improved. Told him cheap on CL he said will watch for one!!!
http://www.jettools.com/eu/en/p/jwts-10 ... saw/708100
Thats what I got for a good deal

My double bearing quill came Friday and got it installed and I wasn't sure how much of a difference it would really make but apparently it does make a big difference. Just jointed and ripped some 2x6 for a 2x bed someone requested using a Shopsmith combo blade and barely a saw mark on them. I'm convinced.