Shopsmith Forums

rpd wrote:

ERLover wrote:

jsburger wrote:

Huh? I think you better look again at the chart you posted.

What am I missing John?

The chart says 425 low speed , you posted 250, Not every one has the larger pulley for the drive sleeve.

Yeh, what he said.

JPG wrote:

ERLover wrote:An error on JPGs part.
The speed changer has two ranges. Belt changes are only required for changing the RANGE. Spindle speeds available are 250 - 1600 and 1850 - 6800.

Happy to have made thy day!!!! !!!!!

JPG posted 250, see above, I posted his quote and the chart, he then and went back and edit and corrected his original.
I did not think I had a Martini yet.

Y'all ain't paying attention!!!!!

Attributing the contents of a quote to the current poster is at best just plain wrong.

Details Details Details

Ah, I see now.
It would be easier for us to follow if you don't edit out the headers and footers so that the software displays quotes properly like this.

ERLover wrote:An error on JPGs part.

JPG wrote:The speed changer has two ranges. Belt changes are only required for changing the RANGE. Spindle speeds available are 250 - 1600 and 1850 - 6800.

ERLover wrote: I did not think I had a Martini yet.

PS A "Martini" is not required for a spirited debate.

ERLover wrote:

JPG wrote:

ERLover wrote:An error on JPGs part.
The speed changer has two ranges. Belt changes are only required for changing the RANGE. Spindle speeds available are 250 - 1600 and 1850 - 6800.

Happy to have made thy day!!!! !!!!!

JPG posted 250, see above, I posted his quote and the chart, he then and went back and edit and corrected his original.
I did not think I had a Martini yet.

By the time I read JPG's post he had corrected it. Your post with the chart does not appear to me to be a quote of JPG.

I am not the only one. RPD read it the same as me.

rpd wrote:Ah, I see now.
It would be easier for us to follow if you don't edit out the headers and footers so that the software displays quotes properly like this.

ERLover wrote:An error on JPGs part.

JPG wrote:The speed changer has two ranges. Belt changes are only required for changing the RANGE. Spindle speeds available are 250 - 1600 and 1850 - 6800.

ERLover wrote: I did not think I had a Martini yet.

PS A "Martini" is not required for a spirited debate.

Absolutely!

I was not paying attention either!

But then I am accustomed to 'him' messing around inside an other's quote.



So it was 'his' fault!



Ohhh and my initially making a mistake is irrelevant.

The Martini remark was that I had a clear head.
I did not edit out the person I was quoting. That is how it showed up in my reply box. Is there a setting for that?

ERLover wrote:The Martini remark was that I had a clear head.
I did not edit out the person I was quoting. That is how it showed up in my reply box. Is there a setting for that?

This is a test.