Shopsmith Forums

ecom1 wrote:If atheist' not correct, let me know

The spell check and I are NOT getting along, lol

test

Wow, that worked! Last time I tried I was using a different user setting - thanks guys!

ecom1 wrote:

ecom1 wrote:If atheist' not correct, let me know

The spell check and I are NOT getting along, lol

'all this'?????

JPG wrote:If atheist' not correct, let me know

Was supposed to read "If this is not correct, let me know".

Me too on Spell Check, but the Nuns here have stopped slapping my knuckles with a ruler!!!

Thanks to all who replied, especially ChrisNeilan and ecom1 for the pictures of their similar vintage machine labels. And to JPG for correcting me on picture size limits ... I usually resize my pictures to 150 dpi, 10" wide, so my width is usually 1500 and height is 1000 since my camera is set to 35 mm standard 3:2 ratio. I had part of the right numbers, just got them in wrong position.

Attached is a pdf of my re-created CAUTION label for a 1982ish machine, using Chris's photo as my template. I got as close as I could to the font, line spacing, and character spacing using my rusty AutoCAD skills. I'm pretty sure my 1980 label was identical, so next time I'm at the copy store I'll get one made up on clear label stock.

And for easier comparison, side by side:

Mine is faded too so it is no longer readable, but I don't care. I know that you don't turn the speed adjustment with the motor off, so the label isn't important to me.

Hi would you PM me please? Tom

woodmeister wrote:Hi would you PM me please? Tom

Who dat?