Shopsmith Forums

reible wrote:I think it is the B2 version clamp.











Of course if you are in to airplanes it does look a lot like this:

ScreenHunter_02 Dec. 04 18.28.jpg




So a plane model that works as a clamp?

Ed

Yep that was what my subconsciousness saw!!!

Ah so!

Creating two 90° angles at once.

FWIW the flat disk would also work(and eliminate possible feeding irregularities).

Not too many December projects yet.
Did this last night after supper. 1st gavel, harder to get semetric than I thought.

Finished the Doll bed I have been working on and my wife made a pillow and a cover for the foam mattress. This goes with the Armoire I made in 2013. http://www.shopsmith.com/ss_forum/viewt ... 00#p158000

The plans were from Ana White - Doll Farmhouse Bed I did make a few small changes.

If I get time I may make a sofa and chair as well.

These are door toppers and sit on the molding above a door.
A friend of ours has one and wanted some different ones to go with it. The pattern for the cat on the left and the mouse are from here. http://scrollsawworkshop.blogspot.ca/20 ... opper.html

And the cat on the right is from here. http://scrollsawworkshop.blogspot.ca/20 ... opper.html
If you print this one out it needs to be done on 17x22 paper.

Bear claw-style salad tongs made of Sapele with mineral oil finish.

The Doll bed was well received so today I made a love seat, chair and end table to go with it. and this is how it looks with the doll. There should be cushions for the the chair and love seat but her mother can sew them.