Shopsmith Forums

Farmer, yours appears to have, etched upon it, a graphic of the obscure constellation Polygonous.

Just picked one up last month, It fits the 10ER miter slot, but there is a bit of slop. I think some low friction tape should shim that out.
Looking at the manual. it would appear that I didn't get the locating guides.
but they don't look that complicated, should be easy to make a couple from aluminum angle.

http://vintagemachinery.org/pubs/detail.aspx?id=16638

edit I did try it on my Greenie table, close but wouldn't go into the miter slot.