Page 2 of 2
Re: Grip n rip
Posted: Mon Nov 06, 2017 1:01 am
by rpd
Grip n Rip. It sounds like the loosing struggle between sphincter and flatulence.
Re: Grip n rip
Posted: Mon Nov 06, 2017 8:57 am
by ChrisNeilan
rpd wrote:Grip n Rip. It sounds like the loosing struggle between sphincter and flatulence.
That
pushed me over the edge!
Re: Grip n rip
Posted: Mon Nov 06, 2017 9:29 am
by Ed in Tampa
rpd wrote:Grip n Rip. It sounds like the loosing struggle between sphincter and flatulence.
Oh my sides! ROFL!
Re: Grip n rip
Posted: Mon Nov 06, 2017 8:00 pm
by Beave2012
Ended up doing boiled linseed oil with paste wax on surfaces that touch the table saw. I think it should make a decent gift for my father.
Re: Grip n rip
Posted: Mon Nov 06, 2017 10:24 pm
by JPG
Very nicely done!
I just wish I understood it's utility.
Re: Grip n rip
Posted: Tue Nov 07, 2017 9:34 am
by terrydowning
Very nicely done sir. I have some short cut offs that just may find a use in something like this.
I just wish I understood it's utility.
Check out the MicroJig Grr-Ripper for the safety/utility of this tool.
http://www.microjig.com/products/grr-ripper/
This has been on my Amazon wish list for years, but no one seems to want to buy it for me.
Maybe it's time to make my own.
Re: Grip n rip
Posted: Tue Nov 07, 2017 1:54 pm
by thunderbirdbat
[youtube]
https://www.youtube.com/watch?v=Byrc-nK4gIo[/youtube]
This video gives a detailed explanation of the various uses and how to adjust it.
Making one has been added to my project list.
Re: Grip n rip
Posted: Tue Nov 07, 2017 10:34 pm
by Beave2012
Its a nice push block that controls the material on both sides of the blade. It will help to prevent kickback in this way. It's a neat way to add safety while creating a new project to work on. Fun stuff.