Re: Beginning to remove the rust from my 10ER
Posted: Fri Jul 20, 2018 4:35 pm
Thank you! It's been pretty easy so far. The hard work is yet to come.Hobbyman2 wrote:nice job on the restoration
Shopsmith Forums
A woodworking forum for woodworking hobbyist and woodworking projects related and unrelated to the Shopsmith MARK V
https://forum.shopsmith.com/
Beginning to remove the rust from my 10ER
Page 2 of 2
Re: Beginning to remove the rust from my 10ER
Posted: Fri Jul 20, 2018 4:41 pm
While waiting for batch number three to come out of the Evapo-Rust, I started cleaning up the aluminum knobs. I used 320-grit Dremel abrasive buffs in my flex shaft. Knobs that I haven't done yet on the left, cleaned knobs on the right.
- Knobs.JPG (71.02 KiB) Viewed 2240 times