Page 2 of 2
Re: 1981 Headstock Parts drawing for George
Posted: Thu Aug 30, 2018 1:52 am
by everettdavis
JPG wrote:everettdavis wrote:chapmanruss wrote:Hi Everett,
I have to agree with JPG as to 1981???
Who would have made a document for the Shopsmith in 1981 since it was out of production.
Shopsmith Inc. was formed in 1972, and they had been back 9 years in 1981. They were lazy and took an old drawing I suspect.
Everett
Not sure I agree with 'lazy'.
Right you are my friend... strike the word lazy. Perhaps "They
had a person less informed in that who took an old drawing I suspect.
Everett
Re: 1981 Headstock Parts drawing for George
Posted: Thu Aug 30, 2018 2:13 am
by JPG
everettdavis wrote:JPG wrote:everettdavis wrote:
Shopsmith Inc. was formed in 1972, and they had been back 9 years in 1981. They were lazy and took an old drawing I suspect.
Everett
Not sure I agree with 'lazy'.
Right you are my friend... strike the word lazy. Perhaps "They
had a person less informed in that who took an old drawing I suspect.
Everett
I think that much more plausible!
Re: 1981 Headstock Parts drawing for George
Posted: Thu Aug 30, 2018 5:20 pm
by chapmanruss
Sorry all,
My brain was not working correctly on the out of production time. I have removed it from the earlier post. What this shows is what has happened before - using old pictures, diagrams etc. for more current manuals/documents.