mountainbreeze wrote:Cleaver jig! Would this be an good way to drill shelf pin holes?
I think so. However, tolerances between the two adjacent rows would be more critical(rocking shelve).
I'd use this jig to make a full-length drilling template, and then use that template to drill all the shelf supports. That would ensure that all supports for a given shelf are at the exact same height. Especially if you're willing to invest ten bucks in a drill bushing.
Which template hole would the bushing be located in?
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
I think so. However, tolerances between the two adjacent rows would be more critical(rocking shelve).
I'd use this jig to make a full-length drilling template, and then use that template to drill all the shelf supports. That would ensure that all supports for a given shelf are at the exact same height. Especially if you're willing to invest ten bucks in a drill bushing.
Which template hole would the bushing be located in?
Whichever one I’m drilling! I’m thinking slip fit on the bushing, not press fit. Which I suppose could require some futzing around to achieve. But then it might want to spin ... never mind!
mountainbreeze wrote:Cleaver jig! Would this be an good way to drill shelf pin holes?
I think so. However, tolerances between the two adjacent rows would be more critical(rocking shelve).
I'd use this jig to make a full-length drilling template, and then use that template to drill all the shelf supports. That would ensure that all supports for a given shelf are at the exact same height. Especially if you're willing to invest ten bucks in a drill bushing.
Ron Dyck
==================================================================
10ER #23430, 10ER #84609, 10ER #94987,two SS A-34 jigsaws for 10ER.
1959 Mark 5 #356595 Greenie, SS Magna Jointer, SS planer, SS bandsaw, SS scroll saw (gray), DC3300,
I’m thinking slip fit on the bushing, not press fit. Which I suppose could require some futzing around to achieve. But then it might want to spin ... never mind! 
