Page 2 of 2
Re: My Current Table Alignment Jig
Posted: Mon Dec 17, 2018 3:17 pm
by Hobbyman2
I wouldnt say it is a waste of time if you are enjoying the project,,, If you could accurately incorporate the jig to set the miter gage at the same time as well , I think you would have something .
Re: My Current Table Alignment Jig
Posted: Mon Dec 17, 2018 6:56 pm
by JPG
Hobbyman2 wrote:I wouldnt say it is a waste of time if you are enjoying the project,,, If you could accurately incorporate the jig to set the miter gage at the same time as well , I think you would have something .
With a M5, '500' the table front serves that function quite well.
Re: My Current Table Alignment Jig
Posted: Mon Dec 17, 2018 8:58 pm
by claimdude
Thanks Dusty!