Page 2 of 2
Posted: Sun Jan 25, 2009 7:39 pm
by reible
This is the link to the manual that shopsmith has online:
http://www.shopsmith.com/ownersite/prod ... ING730.pdf
Ed
jrjensen
Posted: Mon Jan 26, 2009 12:38 pm
by jrjensen
Thanks Ed, just what I wanted.
Bob
Posted: Tue Jan 27, 2009 4:31 pm
by cincinnati
I sent an e-mail to the Wooden Post dot com and they informed me they were once again able to sell the Shopsmith model. So I guess Shopsmith dropped it.
Posted: Tue Jan 27, 2009 5:58 pm
by reible
Hi,
I too got a message from woodenpost saying:
"We can now sell the Ringmaster for the ShopSmith."
However as of this morning there was no link to do so.
I had also contacted PORTA-NAILS, INC:
"Thank you for your email and bringing the shopping cart functionality issue to our attention. Our Web Master has been made aware of this issue and will be working to correct. We will advise once the fix has been made. In the interim, if you would like to place your order the old fashion way you can call our customer service department at 800-634-9281 and we will be happy to process your order."
http://www.porta-nails.com/woodworking/ring_master.shtml
http://www.ringmastertool.com/PAGES/Lathe.HTM
It should soon be ready at the above sites.
Ed
reible wrote:Hi,
Before these became a exclusive shopsmith item they could be purchased at:
http://www.woodenpost.com/
I had written them due to the fact the ringmaster doesn't seem to be a shopsmith order able item anymore. This is the response:
"I have not been made aware ShopSmith stopped handling it."
I then replied asking if they were checking into it... so still no clear answer if they will again be selling them in the future.
Ed
Posted: Tue Jan 27, 2009 8:43 pm
by cincinnati
Do you know if they ever run sales on the Ring Master?
Posted: Tue Feb 03, 2009 11:20 am
by jayhawk
Thanks for the great info everyone! I just bought a Ring Master on eBay and needed a User Manual. I plan on cutting some rings very soon. I'm lucky and live across the street from a cabinet shop who gives me lots of cut-offs of maple, oak and various other hardwoods that are perfect for this tool. I'll let you know how it goes.
Jay
Posted: Tue Feb 03, 2009 9:54 pm
by a1gutterman
jayhawk wrote:Thanks for the great info everyone! I just bought a Ring Master on eBay and needed a User Manual. I plan on cutting some rings very soon. I'm lucky and live across the street from a cabinet shop who gives me lots of cut-offs of maple, oak and various other hardwoods that are perfect for this tool. I'll let you know how it goes.
Jay
You know what they say: Location, location, location!