[quote="JPG40504"]I do not know if they are "incorrect", only that they differ from my measurements. I just 'remeasured' and 7 1/2" and 8 1/2" are the dimensions I got for your 9 1/4" and 8 3/4"! Also the outside edge of the bench tubes is 3/4" further out (front and rear) from the way tubes(your drawing shows them 7/8").
Notice that we differ on the7 1/2" dimension by the diameter of the tube.]
JPG, et al
Your dimensions are all correct and there are no differences between old and new machines. The differing dimensions that I had recorded were all wrong.
"Making Sawdust Safely" Dusty
Sent from my Dell XPS using Firefox.
I would really really like for someone to measure the ctr - ctr distance of the 505/510/520 main table tubes. I believe it is wider than the 500, but do NOT know how much. It would 'complete' this thread.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
JPG40504 wrote:I would really really like for someone to measure the ctr - ctr distance of the 505/510/520 main table tubes. I believe it is wider than the 500, but do NOT know how much. It would 'complete' this thread.
My 1995 Mark V, with the 510 table system, seems to measure out at exactly 15 1/2", center to center.
Tim
Buying US made products will help keep YOUR job or retirement funds safer.
a1gutterman wrote:My 1995 Mark V, with the 510 table system, seems to measure out at exactly 15 1/2", center to center.
Thank You Tim
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
I just 'remeasured' and 7 1/2" and 8 1/2" are the dimensions I got for your 9 1/4" and 8 3/4"!
Also the outside edge of the bench tubes is 3/4" further out (front and rear) from the way tubes(your drawing shows them 7/8").
