Shopsmith Forums

DLB wrote: Sat Dec 14, 2024 2:27 pm

rlkeeney wrote: Sat Dec 14, 2024 1:22 pm I wanted a new part, but I could not get one.

I would at least try calling CS, if SS is still using the part it should be in their system and they can perhaps sell you one.

- David

Good point.

Robert,

If I understand correctly, you are wanting the Guard part ref. # 213, part number 514359 from the link below. That is the part the Guard Stud ref. # 214 P/N P514486 you wanted to remove and reuse shown in your previous picture.

https://www.shopsmith.com/guards-service-parts

It appears Shopsmith doesn't sell most of the Lower Guard parts individually. If that plastic part is bad what is the condition of the other plastic parts in the Lower Guard and are they worth keeping? Just thinking out loud here.