Shopsmith Forums

Kevin,
Sorry for the delayedresponse; I am working on a small (6x12) log hauling trailer, and I haven't been in the wood shop or looked at the forum for a couple of weeks. Here are pictures with a ruler for scale. One thing to note is that the back slots for sanding discs are angled towards the operator 10 degrees. I used the overhead routing mode with an extra long 5/16" straight bit to cut the slots. I fine tuned the fit with a rasp.

JoeSark,

Very nice Accessory Shelf. Can you post a picture of it with the Accessories on it? It would be nice to see it in use.

In my previous posts I have said I don't use the shelf I made but that's my personal preference. Don't let me discourage anyone from using what works for them.

Russ, my original post shows all of the accessories in their spots on the shelf.

Sorry, wasn't thinking yesterday.

I have days like that!

I like to get a peek in peoples shops to see what good ideas I can glee. Here is my 2x12 shelf and wire rack on the shorty. Also the down draft box on the shorty for the drum sander works great no need to go to drill press mode for dust collection.

The space below the Mark (between the four legs) has always been wasted space in my shop. I have just never done anything about it except to stack tool boxes and park vacuum cleaner or air compressor there.

I use that space for my #12 feet.