Posted: Fri Jun 26, 2009 7:03 pm
Like Dusty said, "Getit you will not be disappointed!"(or he said something very close).mikelst wrote:OK...
I hadn't seen this before, and for one I appreciate your 're-visiting' it.
This looks like the type of tool/setup jig that can save me lots of time but more it can save me lots of aggravation. I get plenty of that anywayand anything that can reduce it is most appreciated. The fact that Dusty likes it says a lot too.
One question, does it come with the Detent Bar or does it need to be purchased separately? The bar IS included. It is used for angles between the pin defined angles(increments of 5°). The bar allows adjusting ±2½° in ½° increments.
I put one (miter-set) on order today.
Mike
OK I went back and looked! Dusty actually said he recommended it! Close enough!