A woodworking forum for woodworking hobbyist and woodworking projects related and unrelated to the Shopsmith MARK V
https://forum.shopsmith.com/
Thanks I have read them all already that is why I am getting so excited about this project. I plan on using this site as a tutorial of sorts and maybe add my own story as well.ddvann79 wrote:There are several 10ER restorations in this thread that you probably want to see.
Message sent and TY!wlhayesmfs wrote:If you want a original get with me through a PM and if you pay the freight I will send you one. I have several in the parts bin and I will not be using them. I mounted one of mine as a perminate drill press and will not be using the one for it at all. These are really fun to rebuild and too bad the 4E mount is broken. I know where there is a 4E around here the guy is trying to sell. Looks in pretty good shape.
Good luck
If it is the pulley set that came with the 4E jointer, it is actually a three step pulley and a separate 5" pulley (to drive the jointer). The pulley set came with two different sized sleeves to adapt the pulleys to either 1/2" or 5/8" motor shafts. I believe the pulleys were bored for 3/4" shafts.JPG40504 wrote:Take good care of the 4 flange Motor pulley! They be quite scarce!
OK! Take good care of the 5" attached pulley.SDSSmith wrote:If it is the pulley set that came with the 4E jointer, it is actually a three step pulley and a separate 5" pulley (to drive the jointer). The pulley set came with two different sized sleeves to adapt the pulleys to either 1/2" or 5/8" motor shafts. I believe the pulleys were bored for 3/4" shafts.
