Shopsmith Forums

Posted: **Mon Jun 20, 2011 8:59 pm**

Let the in-feed side fill up.

Posted: **Mon Jun 20, 2011 9:37 pm**

I find that once the guts of the jointer fill-up with chips the rest seem to go out the DC chute. But after work, cleaning out the chips on the infeed side is a real pain. I want to clean them out since wood chips hold water which can rust cast iron and steel parts.

Hmmm - if I take apart the jointer, might there be a way ???????

Forrest

Posted: **Mon Jun 20, 2011 11:36 pm**

A shop vac is not made to run full time like a dust collector is. But may get by with it in a home shop.

Shopsmith Forums

Keep or sell the DC3300?

infeed fillup works - but after that?