Shopsmith Forums

To all of you who opined on my question. Thank you. I will make him an offer and see if he accepts. I will let you all know what happens. He lives in my town so it is at least convenient. Again, thanks for the great advice and please excuse my newbie questions.

Rick:)

rick42_98 wrote:Thanks BigJohn1. I will check the serial nbr and hope that will tell me if I am getting 1 1/8 hp. I assume I can always upgrade the tables (can I?) so I will try to get the bigger hp motor. Do you agree?

Rich

Yes I agree with JP for that price you can't go wrong and it has the 1 1/8 motor. I also think the 3/4 is fine also for what ever needs to be done.
You will find more do's and don'ts after you have one.

rick42_98 wrote:To all of you who opined on my question. Thank you. I will make him an offer and see if he accepts. I will let you all know what happens. He lives in my town so it is at least convenient. Again, thanks for the great advice and please excuse my newbie questions.

Rick:)

We all had to start at some point in time there is a lot of info to take in.

Actually this the best place to ask 'newbie' questions. The answers are usually dead on and often include the answer to the question you needed to have asked.

No 'apologies' needed!;)