Shopsmith Forums

ChrisNeilan wrote:

ERLover wrote:Beave, just thought about it, no need to sleep on it, and dont need permission or forgiveness!! Ya Dusty pics tomorrow if the camera battery and the 3 step proccess to load and get to on the computer. I may buy a camera phone just for that and email them to me.

Ya bought it, didn't ya!

When I talked to him the first time about 730 he sounded a bit asleep, and said he works till 2 pm, and is available after 230. I called back 20 minutes later to say I would take it and pick up tomorrow, I got voice mail. I bet up early for work and to bed early, now pins and needles till I hear back.

The 'upgraded' 10E rip fence is rare enough to be worth the $100 by itself.

Oh and it IS a 10E.

BTW the table is mounted basakwards.

It got sold underneath me after I called him the first time and told him I was going to sleep on it, and then called back 30ish minutes later, gone.
Oh well they are cheap and often here in WI, but like I said, I need another one like a hole in my foot. Just hope it went to someone who is gong to use it.

You know I must have a house full if I am passing on this one.... $375 10ER with dropdown Jointer and a Speed Changer in McKinney just north of Dallas....

http://dallas.craigslist.org/ndf/tls/5745254420.html

Someone go get this one....

Everett
And I don't have a drop down Jointer either, but I am stacked up on gear.

Shopsmith 10-ER - $95 (Hudson)

http://minneapolis.craigslist.org/wsh/t ... 75478.html

Vintage Shopsmth 10-ER Multi-purpose power tool. This unit has been sitting quite a while, has some rust on the way tubes and is generally dirty. Quill lock lever is broken off. Turns on and is very quiet when running. Not a lot of accessories, just what you see in the picts(cart not included). It has the accessory base with castors and decent wood top. Clean it up and use it or part it out. Call me at 7one54oneo4655

Here it is -- a 1947 Shopsmith for $50. Does it work? Who knows!

http://westernmass.craigslist.org/atq/5721503135.html

Not likely a '47'.

It is an ER.

Pro Planer with 2 sets of blades... $250.... So tempted

http://minneapolis.craigslist.org/csw/t ... 00916.html

Beave2012 wrote:Pro Planer with 2 sets of blades... $250.... So tempted

http://minneapolis.craigslist.org/csw/t ... 00916.html

What to think about??? It is a no brainer

ERLover wrote:

Beave2012 wrote:Pro Planer with 2 sets of blades... $250.... So tempted

http://minneapolis.craigslist.org/csw/t ... 00916.html

What to think about??? It is a no brainer

I don't need 2 pro planers. Maybe just to resell, but I dislike that