Create a review for a woodworking tool that you are familiar with (Shopsmith brand or Non-Shopsmith) or just post your opinion on a specific tool. Head to head comparisons welcome too.
charlese wrote:Wow! That seem pretty fast - most saw blades with brazed on teeth are rated not to exceed 5500 RPM.
That is why I asked, even if that were true should we run an 8" dado blade at 5500 because we can? Would the cut be better, not that I have any issues with the Dadonator cut quality.
Paul Cohen
Beaverton, OR
A 1982 500 Shopsmith brand upgraded to a Mark 7 PowerPro, Jointer, Bandsaw (with Kreg fence), Strip Sander, Ring Master and lots of accessories all purchased new
12" Sliding Compound Mitre Saw, 1200 CFM DC
- most saw blades with brazed on teeth are rated not to exceed 5500 RPM.