Page 3 of 3

Posted: Fri May 25, 2012 1:15 pm
by JPG
wiredone wrote:I think that I would love to see their units so we can put this to rest.
I hate beating dead horses. They start smelling funny after a while.

IIRC, Alec was one, and I cannot recall the 'other' who happens to have two goldies of which one was a Poly-v and one a Gilmer.

Trouble with this horse is, it was once thought to be laid to rest.:rolleyes:

I hate inconsistencies and lack of understanding.:(

Yes it can be said 'who gives a rats a$$', but if one is contemplating acquiring either bench tubes or end castings tis best to unnerstan the possibility of a mis match.:eek:

Posted: Fri May 25, 2012 5:58 pm
by easterngray
If I thought in the past that mine were 1 7/8", I was incorrect. I just took the calipers to mine and they are 1 3/4. Alec

Posted: Fri May 25, 2012 10:32 pm
by JPG
easterngray wrote:If I thought in the past that mine were 1 7/8", I was incorrect. I just took the calipers to mine and they are 1 3/4. Alec
Thank you for checking. My 'recollection' could be inaccurate! I may be connecting with 3/4hp motor.

Ya gots SN?