nothungry3 wrote:I understand the need to protect against reverse rotation, but that is not relevant to set screw retention.
How about the shaft flat angle? My shaft flat is cut at an angle to the shaft centerline. Is this feature common to these models?
Common to ALL ss models.
Only the 'old' Mark VII runs in reverse as original.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
