Page 3 of 3
Posted: Sat Mar 01, 2014 11:58 pm
by JPG
joedw00 wrote:If you are talking about the motor being reverseable no it's not. It just puts the headstock up instead of down like drill press mode.
I thought I saw an extra switch. Cannot tell what it actually is. Still makes sense!;)
Posted: Sun Mar 02, 2014 11:47 am
by joedw00
I replaced the original switch with just a toggle switch. I replaced the original one two times and said the heck with that. Maybe that is what you see.
Posted: Sun Mar 02, 2014 11:54 am
by JPG
joedw00 wrote:I replaced the original switch with just a toggle switch. I replaced the original one two times and said the heck with that. Maybe that is what you see.
???????????????????
[ATTACH]24223[/ATTACH]
Posted: Sun Mar 02, 2014 12:09 pm
by joedw00
I replaced this [ATTACH]24224[/ATTACH] with one like this [ATTACH]24225[/ATTACH]
Posted: Sun Mar 02, 2014 12:42 pm
by idcook
Traditional router table arrangement. Nice.
Having an individual set up for the purpose I hadn’t considered this.
Thanks Joe.
Posted: Sun Mar 02, 2014 1:22 pm
by joedw00
That is the biggest reason I wanted a double tilt because I don't have room for a router table. I don't use it in router mode much but when I want it doesn't take long to have a router table.