Shopsmith Forums

Posted: **Tue Jan 05, 2016 9:02 pm**

I have the Jessem guides on my Mark V (520 Power Pro) and on my router table. Love them! I started out years ago with a ripstrate and used it for a very long time. I then upgraded to the board buddies and used them until Jessem released these. Easy to set up and use. Very effective and adds a good measure of safety top using the table saw. I picked up a couple of pieces of aluminum and made essentially, long SS T Nuts. These are attached to the Jessem fence on the bottom and allow me to slide the whole set up off and on in a few seconds.

Jack

: Jessem instruction page; 2014-11-05 15.08.43.jpg (45.56 KiB) Viewed 2931 times

: Milled aluminum T nuts; 2014-11-07 20.20.33.jpg (70.04 KiB) Viewed 2931 times

: Another view of milled T nuts; 2014-11-07 20.20.44.jpg (55.77 KiB) Viewed 2931 times

: Milled T nut inserted in top of SS fence; 2014-11-07 20.59.10.jpg (93.54 KiB) Viewed 2931 times

: Jessem guides installed; 2014-11-08 13.43.02.jpg (97.22 KiB) Viewed 2931 times

Posted: **Wed Jan 06, 2016 3:26 pm**

Thanks for the photo and review.

Posted: **Wed Jan 06, 2016 3:55 pm**

I made a similar jig for my router table JessEm stock guides. I couldn't see paying another $250 for the table saw version when I can share the one I have for the router table. The downside is the wheels don't extend out as far for the router table guides but like you I also have the board buddies which I use for larger width rips.

Shopsmith Forums

Opinion on use of JessEm Stock Guides on SS

Re: Opinion on use of JessEm Stock Guides on SS

Re: Opinion on use of JessEm Stock Guides on SS

Re: Opinion on use of JessEm Stock Guides on SS