Shopsmith Forums

Posted: **Sat Nov 07, 2015 12:12 pm**

richardrouse wrote:I hadn't seen just how flattened out that part of the cam had become. I wonder if that is due to distortion in the nylon cam i based it on.
I'll have to adjust the model.

Can you, by chance, take a photo of the silver cam's profile head on with a scale in the background? so I can compare the profile I used to create the model and the CNC cam.

close - gotta run!

: cnc cam.jpg (628.53 KiB) Viewed 1016 times

Posted: **Wed Feb 17, 2016 10:27 pm**

how does the speed control cam look when putting back in

Posted: **Wed Feb 17, 2016 11:04 pm**

hobbies wrote:how does the speed control cam look when putting back in

Check the other thread.

Shopsmith Forums

Mark VII speed control

Re: Mark VII speed control

Re: Mark VII speed control

Re: Mark VII speed control