Shopsmith Forums

Posted: **Sat Oct 17, 2015 10:38 pm**

John Burger
Are the backup bearings adjusted OK? Are you talking about the blade leaning towards the rear of the cut?. I generally cut tenon cheeks on the table saw after cutting the tenon shoulders.
I use this fixture for the cheeks

: saddle fixture.jpg (93.86 KiB) Viewed 1646 times

Try cross cutting a 2X4 to see if the bandsaw blade exits the cut evenly from top to bottom. It should.
Bill V

Posted: **Sat Oct 17, 2015 11:05 pm**

Dug through my in progress reorganization to get the manual. In mine it is on page 27.

See below.

: IMG_9799sc.jpg (91.48 KiB) Viewed 1644 times

Ed

Posted: **Sat Oct 17, 2015 11:42 pm**

Remember the wheel and blade is 'canted'! As such, the blade at the bottom of the workpiece leads the top.

Shopsmith Forums

For you digital gauge guys

Re: For you digital gauge guys

Re: For you digital gauge guys

Re: For you digital gauge guys