Page 3 of 3
Re: Miter gauge sticks in track
Posted: Mon Jan 02, 2017 12:16 pm
by JPG
No you are not an idiot!!!!!
If the washer is supposed to be oblong an idiot at the factory should have installed it properly.
However I do not think it is supposed to be oblong.
Call CS and get a replacement.
Re: Miter gauge sticks in track
Posted: Mon Jan 02, 2017 2:40 pm
by kkoyle
Thanks, JPG. I'll call SS tomorrow and have them send out a replacement.
Re: Miter gauge sticks in track
Posted: Mon Jan 02, 2017 5:29 pm
by dusty
Don't rejoice until Shopsmith has sent you a part that works as it should AND is round.
Hmmm. The temporary fix is an oblong washer in a round hole
.
Re: Miter gauge sticks in track
Posted: Mon Jan 02, 2017 5:35 pm
by algale
I'd sure like to see some photos of this defective washer and how it was originally installed.
Re: Miter gauge sticks in track
Posted: Mon Jan 02, 2017 5:36 pm
by ERLover
dusty wrote:Don't rejoice until Shopsmith has sent you a part that works as it should AND is round.
Hmmm. The temporary fix is an oblong washer in a round hole
.
As long as it fits the right way plus some gaps on 2 radiuses
