Shopsmith Forums

You might want to consider a fine 8" wire wheel for your new 'grinder'. A couple came with my 10E and they are quite effective at 'refinishing'. It also came with a smaller brass wire wheel.

JPG40504 wrote:Item 259
http://www.shopsmith.com/ownersite/partscat/mitergaugeexpview.htm

does shop smith still sell this part or does anybody know where i could find a replacement spring ? i too am in the middle of buffing out everything that came with my mk 5 and it's starting to look pretty good . i would just hate to put it back together without that spring if i don't have to.

Mike

beeg wrote:It appears that they do still have em for sale.

http://www.shopsmith.com/ownersite/itemfind.htm?item=501467&Submit=Find+Item

I must not have looked hard enough . but then again how much is shipping ? more than the spring ?