Page 3 of 3
I think
Posted: Thu Feb 10, 2011 3:16 am
by fiatben
I am going to go throw up now.
There are those who stumble and there are those who are on an unending and fruitless search......
Posted: Thu Feb 10, 2011 7:08 am
by mbcabinetmaker
JPG40504 wrote:Is it possible the cams were on backwards??? That and the crank backwards or upside down and 180 out is about all that be mis-assembled(assuming the roll pin holes are back mating the original end casting they were removed from!). Oh and the crank on the correct end(later models have holes drilled in both ends).
I guess anything is possible but I tried all possible alignment options and the final assembly was the closest to the model on my 520 that I could come up with. I think the rods were drilled wrong because they were different than on the 520.
Posted: Thu Feb 10, 2011 7:24 am
by mbcabinetmaker
[ATTACH]11879[/ATTACH]
Final assembly. I am really liking the size of these shorty machines as dedicated tools. This will be set up for 1/4 inch dado's mostly for drawer bottoms. The addition of this machine has however caused a dilemma that I am going to have to think about. Will I or won't I that is the question.
Posted: Thu Feb 10, 2011 1:03 pm
by wlhayesmfs
Great looking shorty, dry spell here since July, not much to find and if I do no money. Must be getting to everyone since the price's are going up on used around here. One guy has has a Bandsaw and DC on Ebay for months and still there, Price is not too high but also not a bargain.
Posted: Thu Feb 10, 2011 10:10 pm
by damagi
a 500+jigsaw followed me home today as well...who would have thought it would fit in a mini cooper
Posted: Thu Feb 10, 2011 10:13 pm
by JPG
Mark: Next time do not tie it up in your truck! Then it might not 'follow you home'!:D
Posted: Fri Feb 11, 2011 12:50 pm
by joedw00
mbcabinetmaker wrote:[ATTACH]11861[/ATTACH]
I stumbled into a deal on this 510 with band saw and jointer. Wasn't even looking.
Notice he had it tied down real good.