Shopsmith Forums

Posted: **Sun Apr 10, 2011 5:45 pm**

prmindartmouth wrote:Just to beat this item totally to death, here is the above bevel gauge mounted on a little board that is clamped to a table slot using a SS t nut:
[ATTACH]12623[/ATTACH]
This view shows the nut:
[ATTACH]12624[/ATTACH]
The rather poor chisel is clamped up with the top of its bevel even with the degree line as seen here. Please ignore the parallax in the photo:
[ATTACH]12625[/ATTACH]

So the top of the bevel is 2" from the front of the clamp?

Posted: **Sun Apr 10, 2011 7:14 pm**

Yes! JPG, right. And thank you for your questions on this and many other threads, which when answered, add considerably to the clarity of the descriptions.

Shopsmith Forums

drill press tool sharpener