Page 3 of 4
Posted: Fri Oct 21, 2011 7:58 pm
by tfeeken
dusty wrote:PS If you come up with another $1500 I would like to solve my clamp problem once and for all. I'll spend the entire amount on an assortment of clamps. I might even have to throw in some mad money to augment that figure.
This is great! Just like Norm would say, you can never have to many clamps!
Posted: Fri Oct 21, 2011 8:03 pm
by judaspre1982
==================================
Posted: Fri Oct 21, 2011 9:29 pm
by fjimp
Most would go to plumbing a shop sink. The balance for hardwoods. Perhaps I would forget the shop sink and just buy hardwoods. fjimp
Posted: Sat Oct 22, 2011 12:30 am
by paulmcohen
gregf wrote:Power Pro upgrade.
I already purchased that before my free $1,500:rolleyes:
Posted: Sat Oct 22, 2011 12:43 am
by damagi
I would spend ~$900 of it on a woodmaster setup off of craigslist when a nice one comes by again. The $600 would probably go toward shop cabinets and other organizational stuff.
Posted: Sat Oct 22, 2011 11:19 pm
by wh500special
My $1500 would be going towards a Sawstop.
Steve
Posted: Sun Oct 23, 2011 11:03 am
by damagi
wh500special wrote:My $1500 would be going towards a Sawstop.
Steve
My wife certainly seemed impressed by the live demo at the local woodcraft.
Posted: Sun Oct 23, 2011 11:56 am
by roy_okc
Paul,
I recently built (still much tweaking to do) a DIY CNC router, ~18"x51"+ capacity. I probably spent close to $1500 just on the non-electronics hardware, around $1000 on the electronics, and around another $grand on software, precise collets, bits, and other miscellaneous stuff.
Thankfully, I'm done with any larger expenditures, at least for now.
I'm already doing some pretty cool things with it, but now have a huge learning curve on software and operating the machine itself.
It is possible to build a complete mid-size system for around $1500, but might have to make some sacrifices that could lead to lower precision, slower, etc. There is a guy working on a design for a small CNC with a goal of $300 for all hardware (Shapeoko)
paulmcohen wrote:If I had to burn $1,500 I would consider a CNC routing system but that might only cover the deposit.
Posted: Sun Oct 23, 2011 12:13 pm
by roy_okc
I definitely need some more shop space. I'd like to add on about 7x12 or so to my existing shop. I also need more electrical circuits brought in. Those are probably over $1500 combined if not each. I desperately need to insulate and side my shop, around $500-750 there.
There's a local (OKC) demo of the new PowerPro & Mark 7 later this week, so I'll probably be drooling over at least the PP. That also blows through another $1500+.
I will definitely be insulating/siding my shop in bits and pieces over the next few months, hopefully finishing before it heats back up next summer. There's a very good chance that I'll be upgrading to a PP in the next 6 to 18 months. Low chance of increasing the size of my shop. Depending on cost, a decent chance of bringing in more power. I also need a better filter on my dust collector and a shop air filter and will probably address these in the next few months.
Roy
Posted: Sun Oct 23, 2011 11:44 pm
by swampgator
Would upgrade my 500 to 520, buy hardwood with remainder if there be any.
