IMHO keakap is dead-on with his opinions/suggestions. This concern has been quite surprising to me. Especially when I remember the extremely protective and outraged comments by some of the folks here when a Shopsmith hater said he would never have one because when he leaned on the table it tilted.
Remember that?
My Table Tilt Lock Needs Some Help
Moderator: admin
I think that was hangin me up because, at least after upgrading to 510, I skipped the benign rips and stuff and went directly to Abuse, wherein all manner of experiments are tried and failed (locks not holding etc.) and only then instructions read. So I had problems from the get-go.forrestb wrote:k...
My calling this a new problem is because in about 15 years I have never had - or at least never noticed, hmmmm - this tilt happening before in benign rips and crosscuts....Forrest
Thinking back on it I'm amazed the machine survived my "Drill Press" period.
O- and a hau`oli makahiki hou to all!
Mark V 520, Power-Pro!; Speed Reducer; B/S; Jointer; ShopMate DCS; SS Tenon Master; Rip-Strate; Incra; BCTW; DW734; var. SS sanding systems; Wood River;