Page 4 of 4
Posted: Fri May 16, 2014 8:00 pm
by dusty
I'll post some pictures of the rip fence. One caveat. The metal bar across the outfeed side of the table is something that I put on this saw. I felt that something was needed to secure the outfeed end of the fence and it appeared that the rip fence was designed for something other than just the edge of the table.
Posted: Fri Oct 17, 2014 7:32 pm
by squashfest81
Heathicus, don't know where your restorations stand. I ran into this bearing info from a link into vintagemachinery.
Craftsman 103.0213 & Dunlap 103.02041 8-inch Tilt-Table Bench Saw
Central Specialty part number: X-1705
Accurate Replacement: 6202ZZ-5/8 (double shields) or 6202LL-5/8 (double seals)
Posted: Sat Oct 18, 2014 8:53 pm
by heathicus
Thanks for the info and inquiry! The table saw and jointer have been sitting "almost finished" for way too long now!