Molding head

Create a review for a woodworking tool that you are familiar with (Shopsmith brand or Non-Shopsmith) or just post your opinion on a specific tool. Head to head comparisons welcome too.

Moderator: admin

Post Reply
charlese
Platinum Member
Posts: 7501
Joined: Fri Dec 08, 2006 10:46 pm
Location: Lancaster, CA

Post by charlese »

algale wrote:Can a shaper be used to put a profile into the face of a board?
Yes, just raise the quill or lower the table, or both. Actually, one can put multiple profiles into the face of a board with little concern.
Octogenarian's have an earned right to be a curmudgeon.
Chuck in Lancaster, CA
Top
Post Reply

Return to “Woodworking Tool Review”