Shopsmith Forums

Steve, you gotta get a life other then Ers!!!!!!!!!!!!

ERLover wrote:Steve, you gotta get a life other then Ers!!!!!!!!!!!!

You're one to be talking!

steve

Ya Steve with being moms care giver, here,SS is my life till it warms up in WI and will get some shop stuff by her. Up here for a few days, sis is in town, going to make the "bench" for nephews Er with the coveted SC,for his dedicated lathe. Again nice present to your bro, the SC!!!!!

tomsalwasser wrote:

rpd wrote:A lovely piece of hardware. I mounted a Record #52 on my bench a couple of months ago.

Thank you Ron. I would really enjoy seeing a picture of your 52 if you get a chance. That link is just what I needed. Much appreciated.

You are welcome.
I posted pictures of the #52's (I got two) in an update on my Woodwork bench build thread.
The one is mounded on the end, (since that photo was posted I have installed wooden jaws liners), I still haven't decided if I will mount the other on the front or if I will make a leg vise.
The #52 is smaller than the #53 but it is a big improvement over the one I had before.

rpd wrote:I posted pictures of the #52's (I got two) in an update on my Woodwork bench build thread. The one is mounded on the end, (since that photo was posted I have installed wooden jaws liners), I still haven't decided if I will mount the other on the front or if I will make a leg vise. The #52 is smaller than the #53 but it is a big improvement over the one I had before.

Very helpful to see your installation Ron, thanks. I am still undecided where to put mine. I have a bench similar to the one below. I was thinking of mounting it on the right face so I could clamp long boards on edge using both vises. Any other ideas?

I found drawing of 18 wheeler truck cut the design out did a little color on it and made a key rack as brother and neighbor always complain about losing keys so put 5 hooks on each one they seemed pleased. live in mountain view ar any ss owner that want to share or brag let me know

I found drawing of 18 wheeler truck cut the design out did a little color on it and made a key rack as brother and neighbor always complain about losing keys so put 5 hooks on each one they seemed pleased. live in mountain view ar any ss owner that want to share or brag let me know

I've been seeing a lot of duplicate posts lately. Is there something going on with the board?

tomsalwasser wrote: I was thinking of mounting it on the right face so I could clamp long boards on edge using both vises. Any other ideas?

Rather than a second vice on the face, Drill a series of holes down the right leg. Then you can put in a support peg at the necessary height to support the right side of the board.

May have to double up the thickness pf the right leg.

Bruce wrote:I've been seeing a lot of duplicate posts lately. Is there something going on with the board?

I would attribute it to cockpit impatience(caused by slow response)