Page 4 of 4
Re: CAD for drafting, woodworking...?
Posted: Sun Sep 23, 2018 7:31 pm
by tenbears
That is the process as described by all the material at YouTube University. Just finished making the "Weggie Sled", plans downloaded at "segeasy.com" Cut a twelve segment ring and a 16 segment ring out of scrap. Glued up the segments right off the Shopsmith, NO gaps what so ever. Big kudus and thanks go out to Jerry Bennett for publicly sharing the process. You can purchase Wedgies from Jerry or if you have a vernier protractor it is a snap to set the angles. With a 2d drawing printed right out of Fusion 360 you can pick the segment dimensions right off the printout. Takes a lot of the mystery out of the process for sure.
Re: CAD for drafting, woodworking...?
Posted: Sun Sep 23, 2018 7:33 pm
by reible
Got pictures?
No pictures then it didn't happen.
Ed
Re: CAD for drafting, woodworking...?
Posted: Mon Sep 24, 2018 1:47 pm
by tenbears
- 12 segments
- IMG_0007 (1).jpg (39.46 KiB) Viewed 8645 times
Picture of the sanded 12 segment ring. 16 segment ring is still under the hose clamp
Re: CAD for drafting, woodworking...?
Posted: Mon Sep 24, 2018 6:41 pm
by Ray17
Amazing, and beautiful. Thank you!
I have trouble making a square picture frame. <g>
Re: CAD for drafting, woodworking...?
Posted: Tue Sep 25, 2018 12:45 am
by JPG
VERY NICE clock frame.
Re: CAD for drafting, woodworking...?
Posted: Tue Sep 25, 2018 12:54 am
by reible
Looking good!
Thanks for sharing.
Ed