Page 4 of 4
Re: Lathe Chucks
Posted: Thu Oct 25, 2018 11:35 am
by wa2crk
One of the features that I like the most about the Talon chuck is the Taper Lock adaptors. When the chuck is used on the SS the set screw prevents loosening and there are no threads to unscrew. One way does make a proper adaptor for the SS and I have not had the set screw loosen when I use it on the Shopsmith. I prefer the Taper Lock adaptors to the screw in type. I have two of the Talon chucks, one set up for the SS and one set up for my Delta lathe.
Whichever one you buy first I am sure you will be happy with it.
Bill V
Re: Lathe Chucks
Posted: Thu Oct 25, 2018 1:15 pm
by geocaljr
JPG - Let us know how your set-up works out.
Re: Lathe Chucks
Posted: Thu Oct 25, 2018 4:47 pm
by JPG
dusty wrote:Why is the fact that it has a grub screw being mentioned (highlighted)?
http://www.shopsmith.com/ss_forum/viewt ... 04#p253104
In the mean time, the thread discussion did change to the quill set screw.
Re: Lathe Chucks
Posted: Thu Oct 25, 2018 8:13 pm
by ChrisNeilan
I must inventory my chucks! One of them is a non-conformist!
Re: Lathe Chucks
Posted: Thu Oct 25, 2018 10:15 pm
by JPG
ChrisNeilan wrote:I must inventory my chucks! One of them is a non-conformist!
Maybe it has been added since thee obtained thy chuck?
You
could add one.
Re: Lathe Chucks
Posted: Thu Oct 25, 2018 11:12 pm
by ChrisNeilan
I have eight chucks at the moment. My name is Chris and I am A chuckaholic!
Re: Lathe Chucks
Posted: Fri Oct 26, 2018 9:50 am
by JPG
ChrisNeilan wrote:I have eight chucks at the moment. My name is Chris and I am A chuckaholic!
I was referring to the grub screw hole!
