Page 4 of 4
Re: Bandsaw Overhaul
Posted: Mon Dec 30, 2019 4:56 pm
by Steele510
rogersk wrote:For what purpose are the two tapped blind holes in the front miter slot of the cast iron bandsaw table? They are seen in the photo of the OP's bandsaw on page 2 of this thread. I have the same bandsaw and have looked in my manual, but can't seem to find the answer.
Keith
The two tapped holes in the miter slot are not blind, they are for the two forward trunnion mounting bolts. The bolts are installed from below the table, which makes the holes appear to be blind viewed from above.
- 7A8C4719-F4A3-412C-912B-27CAD982F3F8.jpeg (67.98 KiB) Viewed 5135 times
Re: Bandsaw Overhaul
Posted: Mon Dec 30, 2019 10:20 pm
by rogersk
Steele510 wrote:
The two tapped holes in the miter slot are not blind, they are for the two forward trunnion mounting bolts. The bolts are installed from below the table, which makes the holes appear to be blind viewed from above.
7A8C4719-F4A3-412C-912B-27CAD982F3F8.jpeg
Wow. Right there hiding in plain sight. Thanks.
Re: Bandsaw Overhaul
Posted: Tue Jan 28, 2020 5:05 pm
by Nelson1020
- Bandsaw Upper Wheel Assembly .jpg (16.81 KiB) Viewed 4466 times
I have an old (cast iron table) bandsaw. there is a bit of play in the upper wheel. How do I get it off to either change or grease the bearing?
Re: Bandsaw Overhaul
Posted: Tue Jan 28, 2020 7:50 pm
by reible
You should find a clip that needs to be removed.
- ring.jpg (100.22 KiB) Viewed 4452 times
Ed