Shopsmith Forums

dusty wrote:

Beave2012 wrote:Here is the link to my Under Shopsmith Storage Cabinet. It works with my 520, the table goes all the way down without issue, the hanging ears are bolted to the cabinet, so I can remove them with 4 bolts and take the whole cabinet off and put it back on w/o any lifting or moving of the shopsmith. Over the last year or so I have had it, I have yet to run into any issues with size or impeding function. The only thing I am not a fan of is the "junk" middle cabinet door. I need to just remove the hinges and put in drawers... but that's a whole different post.

It uses a single 4'x8'x3/4" sheet of baltic birch plywood, door hinges, and 4 bolts (plus dividers/shelves as desired). The whole plan for it, including cuts is in the PDF on the first post as well. Made pretty much entirely with the shopsmith (even used the horizontal boring function).

**Note: this was one of my first postings on this site, I don't think Dusty and JPG liked my initial post. Don't worry about that, I think they might recognize me now.

http://www.shopsmith.com/ss_forum/begin ... 16336.html

Full Cab pict.jpg

I am sorry that I gave you that impression. I just reread that thread and I see absolutely nothing wrong with your post. There was some battering back and forth (JPG and I) but that sort of thing happens here all the time (probably should not). I just look through the pictures that you posted. All I can say is "Excellent Job on both the cabinet and the post).

Again, Sorry.