Shopsmith Forums

Posted: **Fri Mar 10, 2017 3:45 pm**

Coffee Table and end tables.
Had a customer who wanted these made from cherry and walnut harvested from his father's land in Tennessee.
Wood had been air dried in his garage for about ten years/ His father had previously had it in his garage for about 15 years.

The pictures were taken minutes before he arrived to pick up the tables.

: IMG_0560.JPG (149.59 KiB) Viewed 6243 times

: IMG_0562-2.jpg (162.39 KiB) Viewed 6243 times

: IMG_0563-2.jpg (148.01 KiB) Viewed 6243 times

Posted: **Fri Mar 10, 2017 3:50 pm**

Old world meets modern day geek

Years ago I remodeled a room for a lady ,,, she wanted me to haul it off ,, the old cord was bad and had shorted out , she said had she not been home it would have burnt the house down.

I did what i could to try and restore the old electronics with no luck.
So I gutted it,,, added a transformer and a modern stereo and speaker , I re-did the fabric and totally refinished the radio

: 20170310_154041.jpg (145.73 KiB) Viewed 6239 times

Posted: **Fri Mar 10, 2017 6:01 pm**

I always stand in awe of the work done by the people on this sight.

Posted: **Fri Mar 10, 2017 7:17 pm**

wrmnfzy wrote:I always stand in awe of the work done by the people on this sight.

Yep some real Craft persons here!!!

Posted: **Fri Mar 17, 2017 11:15 am**

A few years ago I built this 24 ft sailboat designed by Phil Bolger. Flat bottom, sailing/rowing boat with lexan side windows and fully open cockpit for and aft. Off-center mast and swing keel. Sails and rows very well!

Posted: **Fri Mar 17, 2017 5:50 pm**

That had to take a while!!

Nice

Shopsmith Forums

projects you are the most proud of

Re: projects you are the most proud of

Re: projects you are the most proud of

Re: projects you are the most proud of

Re: projects you are the most proud of

Re: projects you are the most proud of

Re: projects you are the most proud of