Shopsmith Forums

Thanks Lyall, snagged it today, and he is coming up to Milwaukee Saturday for a graduation not to far from moms and bringing it up to me, delivered besides, how cool is that Saved me a drive
https://rockford.craigslist.org/tls/5599528214.html

ERLover glad to help.
Need pictures of it when you get it or after you clean and fixed it up.
someday I will get a 10e or 10er.

lyall wrote:ERLover glad to help.
Need pictures of it when you get it or after you clean and fixed it up.
someday I will get a 10e or 10er.

I sure will, and I still owe Dusty some, just been a little extra busy with mom this past week and a bit lazy, and the process from camera to site to desk top then to here. By the pic posted it does not look like it will need much or any clean up. Just cant figure out on the tail end looks like a table saw attached to it.

ERLover wrote:

lyall wrote:ERLover glad to help.
Need pictures of it when you get it or after you clean and fixed it up.
someday I will get a 10e or 10er.

I sure will, and I still owe Dusty some, just been a little extra busy with mom this past week and a bit lazy, and the process from camera to site to desk top then to here. By the pic posted it does not look like it will need much or any clean up. Just cant figure out on the tail end looks like a table saw attached to it.

Looks like a ts on a shelf attached to the wall behind the 10.

@ JPG>
Looks like a ts on a shelf attached to the wall behind the 10.

That was kinda my thought too/possibility.

http://eugene.craigslist.org/tls/5620017140.html
Shopsmith - $150 (Springfield, OR.)

A bit of a drive from WI but the price is a real bargain with a speed changer, since the SC sell for about $175 on Ebay alone. I would NEVER do that,strip one for EBay, Blasphemy.

ERLover wrote:

lyall wrote:ERLover glad to help.
Need pictures of it when you get it or after you clean and fixed it up.
someday I will get a 10e or 10er.

I sure will, and I still owe Dusty some, just been a little extra busy with mom this past week and a bit lazy, and the process from camera to site to desk top then to here. By the pic posted it does not look like it will need much or any clean up. Just cant figure out on the tail end looks like a table saw attached to it.

I thought from the look of the fence it might be a router table, but I found this photo of a TOOLKRAFT Shaper on Vintage Machinery that looks like its twin, so that would be my guess.

The bar that runs over the10er is a bit puzzling. Not very clear in the photo but that might be a router mounted on the bar to put flutes on spindles?

Thanks RPD, i guess I will see on Saturday when he delivers the stuff. Sure looks like it.

RPD I am a table router guy with carbide, but from my SS purchases I have so many HS Steel Shaper bits, I hope they fit, but sure I will never use them, some of the SS ones are in there original boxes wrapped in oil paper, never used.