Page 1 of 1
Missing Washer on Quill Feed
Posted: Wed Mar 14, 2012 3:16 pm
by BuffaloBill
Somehow in my Headstock Rebuild I've managed to lose the simple washer on the Quill Feed. Ref # 37 on the Parts Diagram, Part # 501627 in their Catalogue.
It seems a waste (Time, money, fuel) to order one online. Does anybody know the dimensions of it so I can see if there is a suitable replacement at a Hardware store.
Cheers,
Cody
Posted: Wed Mar 14, 2012 4:05 pm
by fgrule
BuffaloBill wrote:Somehow in my Headstock Rebuild I've managed to lose the simple washer on the Quill Feed. Ref # 37 on the Parts Diagram, Part # 501627 in their Catalogue.
It seems a waste (Time, money, fuel) to order one online. Does anybody know the dimensions of it so I can see if there is a suitable replacement at a Hardware store.
Cheers,
Cody
It's a simple, flat, thin steel washer. I just measured it:
O.D.=1.250"
I.D.=0.750"
thickness=.03"
It's the same size as the serrated washer, but thinner.
Fred
Most excellent.
Posted: Wed Mar 14, 2012 7:25 pm
by BuffaloBill
Thanks very much for the information.
I'll see if I can find one somewhere or maybe just make 1 somehow.
Cody
Posted: Wed Mar 14, 2012 10:15 pm
by JPG
BuffaloBill wrote:Thanks very much for the information.
I'll see if I can find one somewhere or maybe just make 1 somehow.
Cody
If old enough, it did not have one to begin with!;)
How old is old enough??
Posted: Fri Mar 16, 2012 1:56 pm
by BuffaloBill
Do yo know what year they started adding them?
Cheers,
Cody