Page 1 of 1
I'm very new and have a question
Posted: Sat Mar 31, 2012 5:11 am
by lightnin
I have searched for a vacuum chuck for Shopsmith and all I could find was a brand name that supposedly makes one for Shopsmith but I could not find a link to anyplace I could buy one. It's called VacuuMaster designed for solid shaft lathes. Would anyone know where to find them?
Posted: Sat Mar 31, 2012 5:15 am
by dusty
lightnin wrote:I have searched for a vacuum chuck for Shopsmith and all I could find was a brand name that supposedly makes one for Shopsmith but I could not find a link to anyplace I could buy one. It's called VacuuMaster designed for solid shaft lathes. Would anyone know where to find them?
Did you try
here?
Posted: Sat Mar 31, 2012 5:24 am
by lightnin
Yes that's where I seen most of the talk about it but I can't seem to find a link to sell them.
VacuuMaster chuck
Posted: Sat Mar 31, 2012 6:14 am
by jimthej
They are available
http://www.sierramold.com/Wtools.htm, but I don't see a SS adapter.
Posted: Sat Mar 31, 2012 10:14 am
by damagi
dusty wrote:Did you try
here?
The site linked in that post seems to have moved here:
http://wonderfulwood.com/articles/
None of the links on the page seem to work, but if you replace the "
http://www.enter.net/~ultradad/" with "
http://wonderfulwood.com/articles/" then they seem to work.
http://wonderfulwood.com/articles/vacuumchuck.html
http://www.bobchapman.co.uk/html/for_woodturners.html was mentioned in another thread. it has a design for a rotary adapter for solid spindle lathes.
http://www.sierramold.com/Wvchuck.htm has the VacuuMaster. In theory you could use a "0520 Threaded Adapter (1”]
http://www.vicmarc.com/default.asp?contentID=548[/url] - Rotating Union 10mm inlet - to suit vacuum hose. Part No. V01216. Looks like you would use VM120/150 Insert "Blank 5/8" Through Hole V00597" to adapt it to the shopsmith.
Posted: Sat Mar 31, 2012 3:56 pm
by lightnin
Thank you for the responses.
I'm still in the process restoring of my new (1956) Shopsmith.
I used it about 15 minuets before the motor started poppin' the breaker.
After watching lots of videos I took it apart and found lots of work to do.
So with 15 minutes of experience I'm addicted to wood turning.
I made a new knob for one of my Stanley 45's.
I have purchased a Oneway Talon chuck and jumbo jaws.
I wonder
would anyone know if the adapter for the Talon
or any other chuck on this page.
http://www.leevalley.com/en/wood/page.a ... 91&p=45612
would fit the VacuuMaster
http://www.sierramold.com/Wvchuck.htm
It's just a matter of three holes lining up right