Shopsmith Forums

Posted: **Sat Apr 07, 2012 1:10 am**

http://www.popularwoodworking.com/tools ... 1#comments

I was wondering if anyone has seen the hub cover bolted on the side of the PowerPro in the pic? Have a part number?

Thanks

Posted: **Sat Apr 07, 2012 2:02 am**

backhertz wrote:http://www.popularwoodworking.com/tools/the-new-mark-vii-from-shopsmith/comment-page-1#comments

I was wondering if anyone has seen the hub cover bolted on the side of the PowerPro in the pic? Have a part number?

Thanks

IMHO that is a very unnecessary addition. I believe it was created for off shore requirements.

Posted: **Sat Apr 07, 2012 6:14 am**

backhertz wrote:http://www.popularwoodworking.com/tools/the-new-mark-vii-from-shopsmith/comment-page-1#comments

I was wondering if anyone has seen the hub cover bolted on the side of the PowerPro in the pic? Have a part number?

Thanks

I don't have a part number, but it came bolted to my PowerPro.
Dick

Posted: **Sat Apr 07, 2012 7:36 am**

backhertz wrote:http://www.popularwoodworking.com/tools/the-new-mark-vii-from-shopsmith/comment-page-1#comments

I was wondering if anyone has seen the hub cover bolted on the side of the PowerPro in the pic? Have a part number?

Thanks

It is known as the Auxiliary Spindle Shaft Guard (Shaft Guard) and its part number is 521889.

PS Well, it used to be. The Part Number Search returns "Item Number 521889 was not found".

Hmmm: Power Pro Part Numbers ????

If you want one, call customer service with this part number. I am certain that it is a good number!

Posted: **Sat Apr 07, 2012 1:21 pm**

Here's a link to the installation instructions. It showed up on my main owner's page several months ago.

http://www.shopsmith.com/ownersite/prod ... tGuard.pdf

John

Shopsmith Forums

Hub Protective Cover?

Hub Protective Cover?