Shopsmith Forums

Posted: **Thu May 03, 2012 8:40 pm**

Hello.
I just purchased a Mark V from a friend. He bought it new about 30 years ago. The serial number is 84361.
Am I able to put a saw guide (upper and lower) on the table? It is the original small one.
Thanks.

Posted: **Thu May 03, 2012 10:10 pm**

dmsokol wrote:Hello.
I just purchased a Mark V from a friend. He bought it new about 30 years ago. The serial number is 84361.
Am I able to put a saw guide (upper and lower) on the table? It is the original small one.
Thanks.

easiest answer is to buy the retrofit saw guard setup from shopsmith and you will be set

Posted: **Fri May 04, 2012 6:24 am**

Thank you. I couldn't find one. Would you happen to have a part number?

Posted: **Fri May 04, 2012 9:41 am**

This should work for ya.

http://www.shopsmith.com/ownersite/cata ... system.htm

Shopsmith Forums

upper and lower saw guides

upper and lower saw guides

retrofit guards