Page 1 of 2
Wooden Tool Holder
Posted: Tue Jun 26, 2012 9:23 pm
by Meester
I just purchased a Shopsmith Mark V, model 500, 1982 I think. Anyway, I'm still trying to figure out how to clean it up. It didn't come with a manual. Anyway, my question is hopefully simple. There is a board attached to the legs of the SS about a foot off of the floor. I know it's to hold all of the attachments but for the life of me I don't know what attachment goes where. So far it is just a piece of wood with some holes and dowels and slots on it. Ok I have figured out where a couple of things go. I was wondering if someone had one and could take a picture of it loaded with the attachments so I could see where things go. That's all, more questions to come later about cleaning and oiling and . . . Now off to the store to find some Johnson floor wax.
Posted: Tue Jun 26, 2012 10:38 pm
by cincinnati
Posted: Wed Jun 27, 2012 12:32 am
by paulmcohen
Most likely it is the second link above. The top link is for a newer shelf but it also could fit a 500. If you have the newer one use the bottom link as a guide of where to put stuff.
re: Wooden Tool Holder
Posted: Wed Jun 27, 2012 2:31 pm
by Meester
Wow, I didn't expect such a quick reply. My shelf is very similer to these, but not exactly the same. I think the guy I bought it from got his shelf later on. Anyway, I think from these pictures I can hopefully figure it out.
Posted: Wed Jun 27, 2012 2:44 pm
by JPG
Meester wrote:Wow, I didn't expect such a quick reply. My shelf is very similer to these, but not exactly the same. I think the guy I bought it from got his shelf later on. Anyway, I think from these pictures I can hopefully figure it out.
Quick? You posted the ? last night!:D That was almost 14 hours ago!:rolleyes:
Posted: Wed Jun 27, 2012 5:48 pm
by dusty
JPG40504 wrote:Quick? You posted the ? last night!:D That was almost 14 hours ago!:rolleyes:
First Responder was there in a little over 1 hour.
Re: Wooden Tool Holder
Posted: Mon Feb 02, 2015 1:19 pm
by jspiceraa
Go to:
http://www.shopsmith.com/ownersite/prod ... yShelf.pdf. There is a PDF file. I would like to see a picture of the board without the tolls. I want to build one. Good luck. Jack
Re: Wooden Tool Holder
Posted: Mon Feb 02, 2015 1:24 pm
by jspiceraa
Where may I get a picture of the wooden tool holder without anything on or in it?
Jack
Re: Wooden Tool Holder
Posted: Wed Feb 04, 2015 5:23 pm
by peterm
Not sure if this is the one you are looking for:
Re: Wooden Tool Holder
Posted: Thu Dec 22, 2016 5:09 pm
by pabcab
how do I get plans to make one?
