Page 1 of 1
interesting combo of 510 and VII
Posted: Wed Jun 27, 2012 12:17 pm
by peterm
Just ran across this combination of a Model 510 mounted on a Model VII double tilt base in a CL listing in B.C.:
[ATTACH]17851[/ATTACH]
[ATTACH]17852[/ATTACH]
Would it be of limited usefulness when tilted left if the table (or motor) is not reversible?
Posted: Wed Jun 27, 2012 12:29 pm
by JPG
Shhhhhhhh!
Do not let farmer see that!:D
Posted: Wed Jun 27, 2012 1:09 pm
by fredsheldon
prmindartmouth wrote:Just ran across this combination of a Model 510 mounted on a Model VII double tilt base in a CL listing in B.C.:
[ATTACH]17851[/ATTACH]
[ATTACH]17852[/ATTACH]
Would it be of limited usefulness when tilted left if the table (or motor) is not reversible?
With the PowerPro upgrade I would think it would be very useful.
Posted: Thu Jun 28, 2012 10:39 am
by dforeman
That looks like what I was thinking of doing with the Mark VII I picked up back in the spring.
Posted: Mon Jul 02, 2012 12:34 pm
by billmayo
I have the Mark V & VII parts to assembly the same Shopsmith for my future use. I had been using the Mark VII reversible motor with home made mounts to fit in the Mark V headstock to provide the reverse operation. I also converted some Mark V motors for the reverse operation for use on the Mark V.
Posted: Wed Jul 04, 2012 9:05 am
by peterm
hanako99 reported to admin as probable spammer
Posted: Wed Jul 04, 2012 9:17 am
by peterm
Here is a primitive tool similar to a Shopsmith:
[ATTACH]17891[/ATTACH]
I ran across it here:
http://missouri.freetoolshopper.com/too ... -tool.html
It appears to rotate into the vertical drill press mode too.
Posted: Wed Jul 04, 2012 2:43 pm
by JPG
Posted: Wed Jul 04, 2012 2:50 pm
by pennview
There's a similar looking machine here --
http://philadelphia.craigslist.org/tls/3063047464.html --
This one comes with a jointer that resembles the Shopsmith jointer.
Posted: Wed Jul 04, 2012 3:02 pm
by beeg
JPG40504 wrote:Go Get it BEEG!:D
NOPE, I'll leave it for TomK. 
